Master-force 252-8020 Manual del operador descargar pdf (Pagina 13)

Page 12

OPERATION

CHARGING A HOT

BATTERY PACK

If the battery pack is above the normal

temperature range, the red LED will

illuminate and the green LED will be off.

When the battery pack cools down to

approximately 104°F (40°C), the charger will

automatically begin charging.

CHARGING A COLD

BATTERY PACK

If the battery pack is below the normal

temperature range, the red LED will

illuminate and the green LED will be off.

When the battery warms to a temperature

of more than 41°F (10°C), the charger will

automatically begin charging .

DEFECTIVE BATTERY

If the charger detects a problem, the red LED

will begin ﬂashing and the green LED will be off.

1. If registering as defective, remove and

reinsert the battery pack in the charger.

If the LED status reads “defective” a

second time, try to charge a different

battery pack.

2. If a different battery pack charges

normally, dispose of the defective

battery pack (see Maintenance section).

3. If a different battery pack also indicates

“defective,” the charger may be defective.

WALL-MOUNT HOLES

The charger has hanging holes for

convenient storage. Install screws in the

wall 2-1/8 inches apart.

Use screws sufﬁciently strong to hold

the combined weight of the charger and

battery pack.

TO ATTACH BATTERY PACK

(FIG.4)

CAUTION:

Avoid the possibility

of accidental starting, always take care

not to activate the trigger switch when

you are attaching the battery pack or

performing other adjustments to the tool.

1. Align the raised portion on the battery

pack with the grooves on the bottom of

the metal shears, then attach the battery

pack to the metal shear as shown.

2. Make sure that the latch on the

battery pack snaps into place and

battery pack is secured to tool before

beginning operation.

CAUTION:

When placing the

battery pack in the tool, be sure that the

raised rib on battery pack aligns with

the groove on the metal shear and the

latches snap into place properly. Improper

assembly of the battery pack can cause

damage to internal components.

TO DETACH BATTERY PACK

1. Depress the battery release buttons

located on the both sides of the battery

pack to release battery pack.

2. Pull battery pack out and remove it from

the tool.

FIG. 4

DETACH

ATTACH

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios