page 13
Recommended Nailing Materials for the
Auto Hammer
The Auto Hammer can be used for driving
nails into all types of woods, wood-like
materials, and plaster board.
NOTE:
This tool is not suitable for driving
nails into hard metal or concrete.
MAINTENANCE
Before each use:
Inspect the auto hammer, the trigger
switch, and the cord for damage.
Check for damaged, missing, or worn parts.
Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
If abnormal vibration or noise occurs,
turn the auto hammer off immediately,
and have the problem corrected before
further use. Remove the battery from the
tool before cleaning or performing any
maintenance. Using compressed air may
be the most effective cleaning method.
Always wear safety goggles when
cleaning tools using compressed air.
WARNING:
When servicing, use
only identical replacement parts. Use of
any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety
goggles or safety glasses with side
shields during power tool operation or
when blowing dust. If operation is dusty,
also wear a dust mask.
WARNING:
To avoid personal
injury, always remove the battery pack
from the tool when cleaning or performing
any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents. Use clean cloths to remove dirt,
dust, oil, grease, etc.
WARNING:
Do not at any time
let brake uids, gasoline, petroleum-
based products, penetrating oils, etc.
to come in contact with plastic parts.
Chemicals can damage, weaken or
destroy plastic which may result in
serious personal injury.
WARNING:
When servicing, use
only identical replacement parts. Use of any
other parts may create a hazard or cause
product damage. To ensure safety and
reliability, all repairs should be performed
by a qualied service technician.
Recommended Nails to Use
The Auto Hammer is versatile for use with a
variety of nails. Nails with a diameter of less
than 7/16”(11mm) and a length equal to or
less than 3-1/2”(8.9cm) are recommended
for use with this Auto Hammer.
Refer to the table below for recommended nails to use:
No Nail Type Size Shank Diameter Head Diameter Length
1 Bright Common 4d 0.1” 1/4” 1 1/2-in
2 Bright Finish 6d 0.091” 9/64” 2-in
3 Bright Finish 4d 0.072” 7/64” 1 1/2-in
4 Coated Sinker 4d 0.08” 13/64” 1 3/8-in
5 Electro Galvanized Roong 4d 0.12” 1/4” 1 1/2-in
6 Hot Tipped Galvanized Finish 10d 0.115” 3/8” 3-in
7 Tempered Hard Trim 6d 0.07” 9/64” 2-in
8 Framing nails 16d 0.1495” 5/16” 3 1/2-in
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales